It has rarely been necessary to reset the AquaVolta® EOS Touch
The AquaVolta® EOS Touch had to be reset a few very few times.
The error manifests itself in the fact that the touch controls do not respond or only respond to a limited extent. This case mostly happened after receiving the water ionizer. And it normally doesn't happen again during operation.
If you ever notice that a reset could be a solution, we ask you to follow the instructions in the picture on the right.
Step-by-step procedure to reset the EOS Touch water ionizer
- First turn off the device using the main switch at the bottom of the device and wait 10 seconds.
- Now touch and hold the touch display at the bottom right corner with your little finger and switch on the EOS Touch. While you continue to keep your finger touching the bottom corner, turn the device back on using the main switch. It is important that you press and hold as far as you can into the corner, preferably with your little finger. After about 10 seconds you can remove your finger again.
- A + symbol should now appear in the top left corner. If that doesn't happen, try steps 1 and 2 again
- Press and hold the plus (+) symbol that appears and keep it pressed until a plus symbol appears again in the lower right corner.
- Also press and hold the newly appeared plus (+) symbol
- When the screen returns to normal mode, you can check the touch button functions and enjoy and enjoy the alkaline ionized hydrogen water with the usual, delicious taste.
Towards the end of the video: Reset EOS Touch 201 - if there are problems with the touch display
All AquaVolta® EOS water ionizers are indestructible - even after years
I have now spoken several times with customers who have been using an EOS water ionizer, then known as the Bionlite Platinion water ionizer, for over 7 years.
All water ionizers were still fully functional. There was a problem with two devices, but it had more to do with rust sediments in the tap water due to the incoming water.
A series many years ago had a program error: If the filter was used until 0 liters were in the display, you could not reset the filter even after replacing the filter. The solution is to replace the display module, which was done very quickly. I found out about this from a sales partner at the time, who was also able to confirm to me that apart from one small program error in a single series, there were no defects so far.
