New mounting option for water ionizers | Intermediate ring with hole for 1/4” water hoses (diameter 6,35mm)
Intermediate ring with rubber seal (O-ring)
Previously, it was necessary to drill a hole in the kitchen cover to connect the water filter or ionizer directly.
We have now developed and had a solution manufactured that allows the water supply hose to be guided through the same hole as the fitting.
This makes it possible to install this much more practical solution in rented apartments.
[Hr]
Two material variants to choose from:
- POM (thermoset):
Diameter: outside 47 mm; Inside 35,5mm; Height: 11mm - Brushed stainless steel:
Diameter: outside 60 mm; Inside 35mm; Height: 11mm - Diameter of the hole for the water hose: 6,5 mm (for 1/4” water hoses)
Video: Permanent connection with the mounting ring | Installation of water ionizer, water filter & osmosis system
Two material variants: 1. made of POM (duroplast), our main recommendation | 2. Made of polished stainless steel
Variant 1: POM (duroplast) > Our main recommendation
Outside diameter: 47 mm, inside: 35,5 mm, height: 11 mm
Variant 2: brushed stainless steel > expensive and too large in diameter, outside diameter: 60 mm, inside: 35 mm, height: 11 mm
Our mounting rings consist only of the intermediate ring made of stainless steel or POM and the rubber seal,
This prevents water from flowing under the ring into the kitchen worktop.
Mounting ring for standard taps | tips and tricks
Note: This solution is sometimes not compatible with old fittings, which usually use a central thread with a central nut to fasten the fitting.
However, the prices of fittings are so low that it may be worth installing a new fitting to take advantage of the direct connection.
Reviews
There are no reviews.