AQUACENTRUM / FAQ / Descaling | Water ionizer maintenance / How do I descale a water ionizer flow regulator (rotary regulator) | e.g. Moses-7, ECA-Plus, Aquion, Dion Family, Nexus?

How do I descale a water ionizer flow regulator (rotary regulator) | e.g. Moses-7, ECA-Plus, Aquion, Dion Family, Nexus?

Descaling a water ionizer with a flow dial

If you own one of the water ionizers listed below, be sure to watch this video.
In short: Make sure that the pump can pump the citric acid solution into the filter. The rotary control should therefore always be set to OFF, i.e. in the off position. The following water ionizers have a flow control dial and are descaled analogously:

Descaling ionizer with flow regulator | Nexus X Blue > The predecessor of the AquaVolta® Moses 7

This video shows the individual descaling steps that must be observed, especially for water ionizers with flow regulators.

According to the latest experience, you can only descale in one pass, you don't have to turn the ionizer on and off between descaling.

The duration can also be extended up to 4 hours depending on the level of use and calcification. If there is severe calcification, please replace the citric acid solution after an hour.

Descaling does not harm the water ionizer in any way. It's exactly the opposite, descaling is good for any water ionizer as long as you use citric acid and not acetic acid.

Link to FAQ post

Categories descaling | Water ionizer maintenance

Leave a Comment

Your e-mail address will not be published. Required fields are marked with * marked

Leave a Comment

Your e-mail address will not be published. Required fields are marked with * marked

 
 
Home
AI assistant
My Account
Skip to content